A low voltage transformer is normally utilized at the user end of the power network. This type of transformer occasionally named as a magnetic low voltage transformer. Transformer of low voltage is a distribution transformer in which both the main and secondary windings planned to activate at system voltages in the low power program.
It is quite simple to wire a transformer of low voltage and even you can tie a low voltage transformer within a small amount of time. To wire a transformer of low voltage here are some basic process given below:
Lets see the few essential things which are required to wire a low voltage transformer:
Cable strippers
Low voltage transformer
Screwdriver
fitted
Philips
rg6 coaxial cable
Here the easy procedure is given to wire a transformer:
The first and foremost thing which you need to do is just watch the label of nameplate that is there on the low voltage transformer as well as the equivalent elevated area or prime connections. In general the elevated sides fatal of the transformer are well-known like the same as 480 VAC inputs and H1, H2 as well as H3, H4 intended for 240. For most of
Security alarm cable the low voltage transformers the 120VAC input could be just a double screw bond. You have to go after the nameplate chart in favor of the entire execution prior to some execution to a transformer.
Next thing you need to do is to just attach the transformer intended for a 230 or 480VAC main input. Now interrelate the H2 and H3 terminals by means of the merchant presented high jumper of metal, otherwise formulate a small cable jumper through banding a small portion of cable with the cable strippers. Consequently affix the jumper by making use of the screwdriver and make tighter the screw fatal to make safe the cable jumper in position.
This is the third step of wiring a transformer in which you need to connect elevated voltage wires or the input to H1 and H2.With the help of X1, X2 and X3, X4 the terminals of low voltage will be recognized . The interrelation
USB extension cable Speaker Cable of the surface of low voltage or secondary terminals subordinates on the elevated side otherwise main voltage.
Now this is the time to terminate the small face of the transformer in support of 480VAC main inputs. As you have done the connection in previous step similar to that you need to connect terminals X2 and X4. Moreover, one of the outputs of low voltage ropes can be attached to any one of them, out of these terminals. It is essential for you to connect X1 and X3 in the similar way as well as the additional wire of low voltage will attach to this joint fatal.